Panasonic DP-3510 Service Manual page 393
Digital imaging system
Hide thumbs
Also See for DP-3510:
- Operating instructions manual (168 pages) ,
- Information sheet (12 pages) ,
- Service handbook (12 pages)
Table of Contents
A
B
(1)
A
(3)
B
Ver. 5.2
5. Height and Perpendicular Position Adjustment
6. Punch Hole Position Adjustment
Before proceeding with this adjustment, make sure
that the Copier's side to side registration is adjusted
properly.
Note:
(2)
393
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(1) Turn the Adjusters to adjust the height or the
perpendicular position of the Finisher to the
machine. (Gaps "A" and "B" should be identical)
(2) Plug the AC Power Cord into the wall outlet and
turn the Main Power Switch on the Back and the
Power Switch on the Left Side of the machine to
the ON position.
(1) Loosen the 2 Screws of the Finisher.
(2) Adjust it to the front or rear accordingly.
Verify that the punch holes are center aligned by
folding a test copy in half. If the holes are not
center aligned, repeat the steps above.
(3) Loosen 2 Screws and adjust the Switch Bracket
position so that it center aligns into the rear cut-
out (between "A" and "B").
JAN 2006
Hide quick links:
Table of Contents
Troubleshooting
