Docking Connector Board - HP Elite x2 1011 G1 Maintenance And Service Manual
Hide thumbs
Also See for Elite x2 1011 G1:
- User manual (103 pages) ,
- Maintenance and service manual (155 pages) ,
- Quickspecs (39 pages)
Table of Contents
Docking connector board
Description
Docking connector board
NOTE:
The docking connector board spare part kit does not include the docking connector
board cable. The docking connector board cable is included in the Slate Cable Kit, spare part number
793721-001.
Before removing the docking connector board, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
5.
Remove the battery (see
Remove the docking connector board:
1.
Remove the following screws:
(1) Four Phillips PM1.9×2.5 screws
(2) One Phillips PM1.5×2.3 screw
(3) One Phillips PM1.5×3.5 screw
2.
Remove the left alignment post connector bracket (4).
3.
Remove the docking connector board bracket (5).
46
Chapter 5 Removal and replacement procedures – slate
Display panel assembly on page
Battery on page
36).
Spare part number
793731-001
32).
- Quick Links:
- Miscellaneous Parts
- Battery
- Rtc Battery
Hide quick links:
Table of Contents
