Table of Contents
FMR-7033 | Installation Instructions | 4.0
Figure 2:
Location of the FMR-7033 Base
Mounting Holes
1
Inside of FMR-7033 Keypad
Back of FMR-7033 Keypad
7
1-
Address Pins
2-
Terminal Strip
3-
Double Gang Mounting Slots
4-
Terminal Strip Opening
DO NOT USE AS A WIRE ENTRANCE.
5-
Sounder Opening
6-
Wire Entrance
7-
Single Gang Mounting Slots
4.0 Wiring the FMR-7033
Ensure that power is removed from all
wiring before routing. Keypad wiring cannot
be shared with multiplex, option bus,
telephone or siren wiring.
Up to three keypads can be used on any
single 1,000 ft (305 m) run of #18 AWG
(1.2 mm) wire. Refer to the FACP's
installation guide for more detailed
instructions.
4
Wiring the FMR-7033
2
DO NOT USE THIS PIN!!
3
4
6
Table 1:
FMR-7033 Wiring Guidelines
Wiring Specifications
Wire Gauge
Wire Type
Maximum number of keypad
allowed per system
Distance allowed between FACP
and Keypad
Maximum distance of keypad
wiring and bus
To wire the FMR-7033 Fire System Controller:
1.
Route the wiring from the FACP to the keypads.
Refer to the FACP's installation guide for details.
2.
Bring the base wiring through the wire entrance
in the keypad's base. Refer to Item 6 in Figure 2
for wire entrance location.
3.
Connect the wiring to the FMR-7033's terminal
strip. Refer to Figure 3.
4.
Place the keypad onto the base.
5.
While feeding the excess wiring out of the rear
of the base, press the cover straight in until it
latches.
Figure 3:
Wiring the FMR-7033's Terminal Strip
5
1
1 - FMR-7033 Terminal Strip
2 - FPD-7024 Option Bus
5.0 Powering the FMR-7033
The power supplied to the FMR-7033 from the R and
B terminals on the FACP is 12 VDC with a maximum
draw of 100 mA per FMR-7033 keypad. This power is
supplied from a 24 VDC battery when AC power fails.
Bosch Security Systems, Inc. | 9/08 | F01U010583-01
Value
#18 AWG (1.2 mm)
Non-shielded; 4-wire
4
2000 ft (610 m)
4000 ft (1219 m)
2
R
B
G
Y
+12V
Com
Data In
Data Out
Hide quick links:
Table of Contents
Troubleshooting
