Table of Contents
Insertion/deletion of segments cannot be confirmed by pressing
gram setup state
Cause
The program setup cannot be changed.
The program being set up is being operated
(RUN. HOLD, FAST, END).
Not pattern item on programming map
Pattern item of non-set segment on program-
ming map
Program deletion cannot be confirmed by pressing
tern items in program setup state
Cause
The program being set up is being operated
(RUN. HOLD, FAST, END).
The program cannot be copied by pressing
Cause
The mode is not the READY mode.
The program of the currently selected pro-
gram No. is not set up.
The controller is in the constant-value opera-
tion mode.
The program is protected.
Key lock is enabled.
General reset is not applied by pressing
Cause
The mode is not the READY mode.
The mode is the MANUAL mode.
Program is protected.
Key lock is enabled.
Chapter 9. TROUBLESHOOTING
Remedy
P R T C
Set program parameter
Reset the controller.
Move to pattern item on programming map.
Either move to already set up segment, or set up
segment.
FUNC
+
Remedy
Reset the controller.
+
PROG
in the basic display state
Remedy
Reset the controller.
Select a program No. whose program is already set.
Set constant-value operation data
P R T C
Set variable parameter
L O C
Set variable parameter
FUNC
+
CLR
+
in the basic display state
DISP
Remedy
Reset the controller.
Execute auto operation.
P R T C
Set variable parameter
L O C
Set variable parameter
FUNC
ENT
+
in pro-
setting to 0.
CLR
while entering pat-
M .O D E
setting to 0.
setting to 0.
setting to 0, 1 or 3.
setting to 0.
setting to 0.
9-7
- Quick Links:
- How to Enter Program Setup
Hide quick links:
Table of Contents
