Table of Contents
Chapter 8. PROGRAM SETUP
Selecting the program No. after entering program setup (continued)
Mode transition
FUNC
+
Program setup state
ENT
key (4)
No.1 setting
entry state
key (5)
Program clear
check state
C L R .
"
8-2
When you select the program No. by this method, the display changes to segment No.1
and the pattern item on the programming map.
This method can be used, for example, to select a program No. to set up a program other
than the No. being operated in the RUN mode. It can also be used to select a program No.
to set up a program other than the currently selected No. by external switch input.
The following diagram shows the transition between modes during program setup.
The following page describes the various mode transition states (1) to (16) in the dia-
gram.
PROG
keys (1)
DISP
key (16)
Setting value display state
ENT
key
FUNC
+
DISP
key (11)
ENT
key
FUNC
CLR
+
keys (6)
CLR
FUNC
+
keys (7)
(pattern item)
ENT
" blinking
key
DISP
key (8)
Basic Display State
key (2)
key (3)
CLR
keys (10)
DISP
key (11)
No.2 setting
entry state
key (9)
FUNC
PROG
+
keys
FUNC
+
keys (15)
FUNC
ENT
+
keys (12)
(pattern item)
Segment insertion
or deletion check
state
I N S .
"
" blinking
d E L .
"
" blinking
key (13)
ENT
key
DISP
key (14)
- Quick Links:
- How to Enter Program Setup
Hide quick links:
Table of Contents
