Displaying Frame Relay To Atm Service Interworking Pvcs; Configuring Terminating Frame Relay To Atm Service Interworking Pvcs - Cisco Catalyst 8540 MSR Configuration Manual
Atm switch router software configuration guide
Hide thumbs
Also See for Catalyst 8540 MSR:
Table of Contents
Chapter 20
Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Displaying Frame Relay to ATM Service Interworking PVCs
To display the service interworking PVC configuration, use the following EXEC commands:
Command
show interfaces [serial card/subcard/port:cgn] Shows the serial interface configuration.
show vc [interface {atm card/subcard/port
[vpi vci] | serial card/subcard/port:cgn [dlci]}]
Configuring Terminating Frame Relay to ATM Service Interworking PVCs
This section describes configuring terminating Frame Relay to ATM service interworking permanent
virtual channels (PVCs). This type of terminating connection provides the connection from IP over
Frame Relay to the ATM switch router used for IP over ATM and network management.
Figure 20-5
Figure 20-5 Frame Relay to ATM Transmit and Terminating Connections
Terminating connections are configured using the frame-relay pvc command; however, all switch
terminating connections use atm0 to connect to the ATM switch route processor.
OL-7396-01
shows an example of transmit and terminating connections.
Frame Relay
ATM switch
UNI/NNI
CPU
Switch
fabric
Configuring Frame Relay to ATM Virtual Connections
Purpose
Shows the PVC interface configuration.
Frame Relay
end system
Frame Relay
network
ATM Switch Router Software Configuration Guide
20-29
Table of Contents
Troubleshooting
