Confirming Connectivity Between The Atm Switch And The Routers - Cisco Catalyst 8540 MSR Configuration Manual
Atm switch router software configuration guide
Hide thumbs
Also See for Catalyst 8540 MSR:
Table of Contents
LANE Configuration Examples
Catalyst 5000 Switch 1
Switch1> session 4
Trying ATM-4...
Connected to ATM-4.
Escape character is '^]'.
ATM> enable
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm 0
ATM(config-if)# lane server-bus tokenring eng_elan
ATM(config-if)# end
ATM# copy system:running-config nvram:startup-config
Building configuration...
[OK]
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm 0
ATM(config-if)# atm pvc 1 0 5 qsaal
ATM(config-if)# atm pvc 2 0 16 ilmi
ATM(config-if)# end
ATM#
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm 0.1 multipoint
ATM(config-subif)# lane client tokenring 1 eng_elan
ATM(config-subif)# end
ATM#
ATM Switch
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface atm 0.1 multipoint
Switch(config-subif)# ip address 172.16.0.4 255.255.0.0
Switch(config-subif)# lane client tokenring eng_elan
Switch(config-subif)#
%LANE-5-UPDOWN: ATM13/0/0.1 elan : LE Client changed state to up
Switch(config-subif)# end
Switch#
Confirming Connectivity between the ATM switch and the Routers
The following example shows how to use the ping command to confirm the connection between the ATM
switch and routers:
ATM_Switch# ping 172.16.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.0.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/202/1000 ms
ATM_Switch# ping 172.16.0.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.0.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/202/1000 ms
ATM Switch Router Software Configuration Guide
14-24
Chapter 14
End with CNTL/Z.
End with CNTL/Z.
End with CNTL/Z.
End with CNTL/Z.
Configuring LAN Emulation
OL-7396-01
Table of Contents
Troubleshooting
