Displaying An Interface Route Optimization Configuration - Cisco Catalyst 8540 MSR Configuration Manual
Atm switch router software configuration guide
Hide thumbs
Also See for Catalyst 8540 MSR:
Table of Contents
Configuring the Soft PVP or Soft PVC Route Optimization Feature
Soft PVP or soft PVC route optimization must be enabled and configured to determine the point at which
a better route is found and the old route is reconfigured.
To enable and configure a soft PVC/PVP interface with route optimization, perform the following steps,
beginning in global configuration mode:
Command
Step 1
Switch(config)# interface [atm
card/subcard/port | serial card/subcard/port:cgn]
Switch(config-if)#
Step 2
Switch(config-if)# atm route-optimization
soft-connection [interval minutes] [time-of-day
{anytime | start-time end-time}]
Example
The following example shows how to configure an interface with a route optimization interval
configured as every 30 minutes between the hours of 6:00 P.M. and 5:00 A.M.:
Switch(config)# interface atm 0/0/0
Switch(config-if)# atm route-optimization soft-connection interval 30 time-of-day 18:00
5:00
Displaying an Interface Route Optimization Configuration
To display the interface route optimization configuration, use the following EXEC command:
Command
show atm interface [atm card/subcard/port |
serial card/subcard/port:cgn]
Example
The following example shows the route optimization configuration of ATM interface 0/0/0:
Switch# show atm interface atm 0/0/0
IF Status:
Auto-config:
IF-Side:
Uni-type:
ConfMaxVpiBits: 8
ConfMaxVciBits: 14
Max-VP:
ConfMaxSvpcVpi: 255
ConfMaxSvccVpi: 255
ConfMinSvccVci: 35
Svc Upc Intent: pass
Soft vc route optimization is enabled
Soft vc route optimization interval = 30 minutes
Soft vc route optimization time-of-day range = (18:0 - 5:0)
ATM Address for Soft VC: 47.0091.8100.0000.00e0.4fac.b401.4000.0c80.8000.00
ATM Switch Router Software Configuration Guide
7-30
UP
Admin Status:
enabled
AutoCfgState:
Network
IF-type:
not applicable
Uni-version:
CurrMaxVpiBits: 8
CurrMaxVciBits: 14
255
Max-VC:
CurrMaxSvpcVpi: 255
CurrMaxSvccVpi: 255
CurrMinSvccVci: 35
Signalling:
Chapter 7
Purpose
Selects the interface to configure. Enter the
interface number of the source end of the
soft PVC/PVP. Route optimization works for the
source end of a soft PVC/PVP only and is ignored
if configured on the destination interface.
Configures the interface for route optimization.
Purpose
Shows the interface configuration route
optimization configuration.
up
completed
NNI
not applicable
16383
Enabled
Configuring Virtual Connections
OL-7396-01
Table of Contents
Troubleshooting
