Table of Contents
3.
Tighten the locknut against the
housing.
Hold the foot firmly and do not change
its height. The locknuts on all four
device feet must be screwed firmly
against the housing.
Electrical connection
:
Warning
Risk of fatal injury!
There is a risk of electric shock if you
touch live components.
Never touch or grasp the mains
■
plug with wet hands.
Only pull the mains cable out of the
■
socket by the plug and never by the
cable as this may damage it.
Please observe the following information
and ensure that:
Clues
The mains voltage and the voltage
■
indicated on the device (type plate)
are the same.
The connected load and required fuse
are specified on the type plate. The
appliance is only connected to an AC
voltage with a properly grounded
■
socket. The plug fits into the socket.
The earth leakage system has been
installed correctly.
■
■
Place and connect
The power cord should only be
■
replaced by a qualified electrician (if
necessary). Replacement connection
cables can be obtained from the after-
sales service. No multiple plugs/
■
couplings or extension cords are
used.
When an earth leakage circuit breaker
■
is used, that only a type with this
symbol is used:
z.
Only this symbol guarantees
compliance with the currently
applicable rules.
The power cable is accessible at
■
all times.
The power cord is not bent,
■
pinched, altered, cut or comes into
contact with heat sources.
or the first wash
before
The device has been thoroughly
inspected before leaving the factory. To
remove any residual test water, the
program
Cotton i90°C the first time without
laundry are performed.
Note:
The device must be properly
■
installed and connected.
~" Place and connect" on page
14
Never switch on a damaged
■
device.
1.
Plug it into the socket. Open the water
2.
tap.
3.
Close the door. Do not put laundry in
the machine.
4.
Select the program Cotton i
90°C.
5.
Open the detergent drawer.
6.
Pour approx. 1 liter of water
into Compartment II.
NL
21
Table of Contents
