Table of Contents
AVIOTEC 8000i IR
Intelligent Defog
Select this to activate the automatic intelligent defog feature. This feature continuously
adjusts image parameters to provide the best picture possible under foggy or misty
conditions.
7.5
Relay settings
The camera includes two built-in relays. Relay 1 (Output 1) that switches in case of a flame
or a smoke alarm. Relay 2 (Output 2) that switches in case of a trouble. The relay are
switched during the alarm/trouble and return to their initial state after the alarm.
You can configure the switching behavior of the output either in Configuration Manager or in
the web browser menu:
Go to Configuration > Alarm > Alarm Outputs
Idle state
1.
2.
Output name
An individual name can be assigned to the relay. The name is shown on the button. The Live
page can also be configured to display this individual name.
Toggle
You can click the button to switch the alarm output manually (for example, for testing
purposes). A green check mark appears to indicate that the relay switches.
Notice!
i
Check carefully the toggle settings before you continue.
Press Set to apply the settings.
Trouble message in case of power loss
If a trouble message is to be triggered in the event of a loss of power or hardware fault,
relay 2 (Output 2) must be set to normally closed (Closed).
Notice!
i
With Tamper detection several settings can be configured to identify troubles (see
corresponding chapter).
The following trouble types can be detected by the various settings:
Trouble type
Sensor fault, lens fault
Bosch Sicherheitssysteme GmbH
Under Idle state select the desired initial state of the relay.
Select from the following options:
Closed: the relay is normally closed.
Open: the relay is normally open.
Prerequisite (setting activated)
Scene quality:
Scene too bright and Scene too dark
User manual
Adjustment of detection settings | en
2023.10 | 02 | F.01U.414.168
49
Table of Contents
