Table of Contents
8.2.2 Configuring the settings related to a memory dump
This subsection describes how to configure the settings related to a memory dump.
Use the following procedure when you want change the memory dump setting to the one
recommended for this equipment. You do not have to follow this procedure if you are already
using the memory dump setting recommended for this equipment, for example, immediately
after the equipment is shipped from the factory, or if you click Yes in " 8.2.1 Memory
Dump Confirmation Messages ".
< NOTE >
Before starting a procedure in this subsection, you must sign in to the local
computer by using an administrator account registered on the computer (as a
member of the Administrators group).
(1) Configuring virtual memory
1. Click Start > Control Panel > System and Security. Then click System.
2. On the left side of the window, click Advanced system settings.
3. On the Advanced tab page, click Settings under Performance.
4. In the Performance Options window, click the Advanced tab.
5. Click Change which is under Virtual memory.
6. Clear the Automatically manage paging file size for all drives check box.
7. In the Drive list, select the drive that stores the paging file you want to change.
For explanation, assume C: (system drive) is clicked here.
8. Select Custom size. In the Initial size (MB) or Maximum size (MB) box, type the
new size of the paging file in megabytes. Then click Set.
Specify the following value for both the initial size and the maximum size based on the
physical memory size.
・If the physical memory size is 8GB: "8316"
・If the physical memory size is 16GB: "16508"
・If the physical memory size is 32GB: "32892"
You can check the physical memory size using the following procedure.
a. Click Start > Control Panel > System and Security.
b. Click System. Then check the value of "Memory(RAM)："
9. Click OK.
8. MAINTENANCE OPERATIONS
8-9
Table of Contents
