Operating Tips; Switching Off The Appliance; Setting The Temperature - Bosch KGN56 Series Information For Use
Hide thumbs
Also See for KGN56 Series:
- Information for use (168 pages) ,
- User manual (140 pages) ,
- Information for use (84 pages)
Table of Contents
en operation
flashes and the status display
lights up red because the freezer
compartment is still too warm.
Switch off the warning tone using
2.
.
(
a
display go out as soon as the set
temperature has been reached.
Set the required temperature.
3.
→ Page 18
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Select the refrigerator compart-
1.
ment using
Press
/
repeatedly until the
2.
temperature display (refrigerator
compartment) shows the required
temperature.
18
) and the status
for ten seconds.
.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→ Page 18
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
Setting the freezer compartment
temperature
Select the freezer compartment
1.
with
.
Press
/
repeatedly until the
2.
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18 °C.
Table of Contents
