Optional Input/Output Modules; Serial Module - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor Plus 7010:
- Owner's manual (126 pages) ,
- Owner's manual (98 pages) ,
- Owner's manual (151 pages)
Table of Contents
Using a screw driver, push and remove the antenna cover from the chassis.
2. Remove the antenna cover from the screw driver and dispose the antenna cover.
3. Align the pins on the clip with the holes on the system board and press the clip to secure the clip to the system board.
4. Push the antennas into the slots on the back of the chassis.
5. Install the nut and washer to secure the antennas to the chassis.
6. Route the antenna cables through the routing guides on the system board.
7. Press the antenna cable into the clip on the system board.
Next steps
1. Install the
wireless card
2. Install the
disk-drive
cage.
3. Install the
3.5-inch hard drive
4. Install the
2.5-inch hard drive
5. Install the
front
bezel.
6. Install the
side
cover.
7. Follow the procedure in
Optional Input/Output modules
Serial module
Removing the serial module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following image indicates the location of the serial module and provides a visual representation of the removal procedure.
Steps
1. Remove the two (M2x5) cross-type screws that secure the serial module to the chassis.
2. Disconnect the serial-module cable from the connector on the system board.
92
Removing and installing Field Replaceable Units (FRUs)
if applicable.
if applicable.
if applicable.
After working inside your
Before working inside your
computer.
computer.
Hide quick links:
Table of Contents
