Table of Contents
GE H
DRAFT
EALTHCARE
D
5394227, R
IRECTION
EVISION
3-6-2-3
During a normal boot, you may observe
A.) Power is distributed to Peripherals, Operator Panel (control panel), Monitor, Front-End and
Back-End Processor.
B.) The Back-End Processor and rest of the scanner starts with the sequence listed in following steps:
1.) "Boot Screen" is displayed.
2.) Back-End Processor is turned ON and starts to load the software.
3.) The Start Screen (LOGIQ™) is displayed on the monitor.
4.) Start-up progress bars indicating software loading procedures, are displayed on the monitor,
NOTE:
Startup GE Healthcare wallpaper with progress bar may differ depending on product type and release.
5.) The software initiates and sets up the Front-End electronics and the rest of the scanner
6.) The Keyboard backlight is lit.
7.) As soon as the software has been loaded, the 2D screen is displayed on the monitor.
3
DRAFT (N
as shown in
Figure 3-12
Figure 3-12 GE Healthcare wallpaper with progress bar
(incl. the clicking sound of the relays on the PID board).
Chapter 3 - Setup Instructions
17, 2011)
OVEMBER
below.
LOGIQ™ S8
S
M
ERVICE
ANUAL
3-23
- Quick Links:
- Typical Users of the Basic Service...
Hide quick links:
Table of Contents
