Table of Contents
GE H
RAFT
EALTHCARE
D
5394227, R
IRECTION
EVISION
3-5-3
Connecting the Color Printer
1.) Power OFF/Shutdown the system as described in:
2.) Connect the Color printer according to correct connection scheme as described in
page
NOTE:
There are three USB ports (stack) on rear panel. The BW printer may be connected to any of the 3x
USB stack connector.
3.) When all the cables are connected, press the Power ON switch on the Color printer.
4.) Power ON/Boot up the LOGIQ™ S8 system as described in
software drivers are pre-installed for the designated Color printer only.
5.) After physical connection to the LOGIQ™ S8 system, assign the printer to a remote key (P1, P2,
P3, P4, P5 and/or P6) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING
WARNING
IEC 60601-1 respectively UL 60601-1.
!! WARNING:
3-14
3
DRAFT (N
3-16.
3-29.
Section 3-5 - Connection of Auxiliary Devices
17, 2011)
OVEMBER
Section 3-6-3 on page
Section 3-7-5 "Remote Control Selection" on page
Section 3-7-4 "Adjustment of Printer
S
ERVICE
3-24.
Figure 3-10 on
Section 3-6-2 on page
3-21. All
LOGIQ™ S8
M
ANUAL
3-37.
- Quick Links:
- Typical Users of the Basic Service...
Hide quick links:
Table of Contents
