Final Steps For Setting Up Compressor Sequencing - Emerson VILTER MicroVission Operation And Service Manual
Hide thumbs
Also See for VILTER MicroVission:
- Operation and service manual (116 pages) ,
- Retrofit manual (20 pages)
Table of Contents
Appendix D • Compressor Sequencing Setup
Final Steps for Setting up Compressor
Sequencing
The MicroVission panels now need to be placed into Seq
Standby mode for the compressor being allowed to se-
quence them. Reference Figure D-14.
At the MicroVission panel Comp2 and Comp3, press the
green UNIT START button, then press the Seq Stand-
By button. This will place Comp2 and Comp3 into seq
standby mode to allow the MicroVission panel to start
in sequencing.
Figure D-14. Placing Compressors in Auto Seq or Seq Stand-By
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
You will see the top banner display "Auto Seq Stand-By"
to signify that the MicroVission panel is now in ready to
run state showing status green checked mark. Reference
Figure D-15. Then press the green UNIT START button,
then press the Auto Seq button on Comp1 to start the
compressor sequencing.
D − 17
Table of Contents
