Setting Up The Microvission Compressor Sequencing Parameters; Adding Microvission Panels To The Devices List - Emerson VILTER MicroVission Operation And Service Manual
Hide thumbs
Also See for VILTER MicroVission:
- Operation and service manual (116 pages) ,
- Retrofit manual (20 pages)
Table of Contents
Appendix D • Compressor Sequencing Setup
Setting up the MicroVission Compressor
Sequencing Parameters
The changes made from compressor will ALWAYS be
synced with all compressors which are configured in
device list.
Adding MicroVission panels to the Devices
List
Now that the network is configured, the next step is
to add the compressors into the sequencing algorithm
and start assigning priorities to the compressors on
the network. To add the MicroVission compressors for
sequencing, navigate to the Compressor Sequencing
screen – page 3 and press the "View Detected Devices"
button, which will display all MicroVission panels those
are reachable. See Figure D-9.
In this example – we have connected two MicroVission
panels to the Ethernet Network. To add these compres-
sors so that it will be included in the compressor se-
quencing algorithm, check the "Add" box as shown in
Figure D-9. Then press the OK button.
After pressing the OK button – you'll be returned to
page 3 of the sequencing screen and you'll see compres-
sors listed in the Device List as shown in Figure D-10.
D − 12
NOTE
Figure D-9. Adding Compressors to Devices List
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Table of Contents
