Trigger Commands - Honeywell HF680 Series User Manual
Hand-free area-imaging scanners
Hide thumbs
Also See for HF680 Series:
- User manual (66 pages) ,
- Quick start manual (14 pages) ,
- User manual (51 pages)
Table of Contents
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on.
Example: What are the device's settings for all Codabar selections?
Enter:
Response:
This response indicates that the device's Codabar Coding Enable (CBRENA) is set
to 1, or on;
the Start/Stop Character (SSX) is set to 0, or Don't Transmit;
the Check Character (CK2) is set to 0, or Not Required;
concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters;
the Maximum Message Length (MAX) is set to 60 characters;
and the Default setting (DFT) has no value.
Trigger Commands
You can activate and deactivate the scanner with serial trigger commands. First,
the scanner must be put in Serial Trigger Mode by scanning a serial menu
command for triggering
trigger is activated and deactivated by sending the following commands:
Activate:
Deactivate:
The scanner scans until a bar code has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see
for a description, and the serial command on
130
cbr?.
CBRENA1[ACK],
SSX0[ACK],
CK20[ACK],
CCT1[ACK],
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
(page
34). Once the scanner is in serial trigger mode, the
SYN T CR
SYN U CR
Read Time-Out
page
136).
HF680 Series User Guide
on page 34
Hide quick links:
Table of Contents
