Table of Contents
Measurement and Analysis
2D length measurement ratio
The measurements
displayed on the 2D
1.
image and the cor-
responding results
2.
are numbered.
3.
4.
5.
Editing 2D Length measurements
1.
2.
3.
4.
2D Area measurements
1.
2.
3.
4.
5.
See the Status bar
6.
to get the next step
7.
to perform.
The measurement
display color on the
2D image changes
from green to red af-
8.
ter completion of
the measurement.
9.
118
Generate the 2D image.
Press
to stop the cineloop.
FREEZE
Press
on the Control Panel.
MEASURE
Select Dist. ratio in the Measurement Menu (see
Figure 6-1).
Perform two length measurements as described in steps 5
through 8 in the above section.
The measurement results including the ratio (%) of the two
measured lengths are displayed in the Measurement result
table.
Trackball the cursor to one of the anchor points of the
measurement to modify.
Double-click the
SET
The selected marker turns green and is unanchored.
With the Trackball, reposition the marker.
Press
to anchor.
SET
Generate the 2D image.
Press
to stop the cineloop.
FREEZE
Press
on the Control Panel.
MEASURE
Select Area (trace) in the Measurement Menu (see
Figure 6-1).
Trackball the cursor to the start point of the measurement.
Press
to anchor the start point of the measurement.
SET
Trace the area (planetary) with the Trackball.
The current area and circumference values are displayed
in the Measurement result table and are instantaneously
updated when moving the cursor.
Press
to complete the measurement.
SET
The measurement result is displayed in the Measurement
result table.
To assign a label to the measurement, see page 115.
key to select the anchor point.
Vivid i User's Manual
2378958-100 Rev. 02
Table of Contents
