Table of Contents
5.10 Start wash programme
Press "Start/Pause" button (Fig. 5-8) to start. Applia-
nce operates according to present settings. Changes
are only possible by cancelling the programme.
5.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED in the button is
flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2.
Turn the knob to select a new programme and start it.
5.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
1. A
t programme cycle end
2.
The appliance switches off automatically.
3. R
emove laundry as soon as possible to go easy on it and to prevent more wrinkl-
ing.
4.
Turn off the water supply.
5. Unplug the power cord.
6 O
pen the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display s-
witches off.
5.13 Act
ivate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the Mix programme.
3. Press the "Temp." button and "Delay" button at the same time for about 3 seconds.
"
" will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again, then "
" will be displayed.
is displayed.
is displayed.
5-Daily sue
se
5-8
16
Table of Contents
