Certification; Spare Parts; Service And Repair - Honeywell HERMetic UTImeter Gtex Chem IIC Operation And Service Manual

Portable gas tight electronic gauging device
Table of Contents

3.5. Certification

Enraf Tanksystem SA is an
ISO 9001 certified
company by Intertek and
MED-D by Det Norske
Veritas Certification
GmbH.
The equipment
has been approved for the
electrical
intrinsic
safety
authorities :
IECEx
Ex ia IIC T4 Ga / -20°C < Ta < +50°C
/ -40°C ≤ Tp ≤ +90°C
Standards used:
IEC 60079-0:2011
IEC 60079-11:2011
ATEX
II 1 G Ex ia IIC T4 Ga / -20°C ≤ Ta ≤ +50°C
Standards used:
EN60079-0:2012 + A11
EN60079-11:2012
Regarding product compliance against standards
updates or new standards, please refer to the
Declaration of conformity.
The equipment has been approved as oil/water
interface
detector
Resolution MEPC.5(XIII) of 13 June 1980 by
National Maritime Authorities and/or Classification
Societies.
If you need a copy of any of these certificates
please contact:
Enraf Tanksystem SA
Rue de l'industrie 2
1630 Bulle, SWITZERLAND
Telephone
: +41-26-91 91 500
Telefax
: +41-26-91 91 505
Web site
: www.tanksystem.com
E-mail
:
50489/GTEX Chem IIC/1805
by
the
following
/ -40°C ≤ Tp ≤ +90°C
according
to
MARPOL

3.6. Spare parts

When ordering spares identify the spare part by
TS number and description. Refer to section
"Drawings".
Some spares might be repairable; in this case
send the part(s) to any authorised service center
or to the factory.
In case of urgency, complete replacement units
can be made available. Contact the factory or
nearest Service Station for details.

3.7. Service and Repair

The customer is responsible for any freight and
customs clearance charges. If units are sent on a
"freight collect" the charges will be invoiced to the
customer.
When returning units or parts for repair to the
factory please fill out a service request form (see
next page). The serial number (letter "G" followed
by 5 digits) is printed on the identification plate as
shown on the Figure 7-1.
When returned to Enraf Tanksystem SA
equipment must be contamination-free. If it is
determined that the customers equipment is
contaminated, it will be returned to the
customer
at
Contaminated equipment will not be repaired
until
such
time
decontaminates the said equipment.
7
the
customers
expense.
that
the
customer
UTImeter Gtex Chem IIC
Table of Contents
loading

Table of Contents