Getting Access To The Component; Safety Notes; Rack Model; Extending The Server Out Of The Rack - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual
Hide thumbs
Also See for PRIMERGY TX1330 M4:
- Upgrade and maintenance manual (519 pages) ,
- Operating manual (110 pages) ,
- Customer service information bulletin (3 pages)
Table of Contents
Basic hardware procedures
4.4
Getting access to the component
4.4.1
Safety notes
CAUTION
▶
Only for non-hot plug components:
● Before removing or attaching covers, turn off the server, all
peripheral devices, and any other connected devices.
● Because there is a risk of electric shock or damage, please
disconnect all power cords from the outlet.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
For more information, see
▶
Only valid for the floorstand model: Do not lift the server by the
front cover in order not to damage the locking clips.
4.4.2
Rack model
4.4.2.1
Extending the server out of the rack
CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Pulling the server out of the rack without having
installed the anti-tilt plate may cause the rack to tip over.
▶
Be careful not to pinch fingers or clothes when sliding out the
server or pushing it back. Failure to do so may cause injury.
▶
For more information, see
▶ Remove all remaining external cables from the I/O panel and expansion
cards.
▶ If you are not using a cable management arm (CMA kit), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
50
"Important information" on page
"Important information" on page
Upgrade and Maintenance Manual
31.
31.
TX1330 M4
Chapters
Table of Contents
