Expansion cards and backup units
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Resuming BitLocker functionality" on page
9.5.3
Replacing an expansion card
Upgrade and Repair Unit
(URU)
Phillips PH2 / (+) No. 2 screw driver (only for installing slot
Tools:
brackets)
Note on network settings recovery
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing the
system board.
Preliminary steps
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the system fan module, see
page
82.
308
79.
81.
47.
"Removing the system fan module" on
Upgrade and Maintenance Manual
121.
Hardware: 5 minutes
Software: 5 minutes
45.
99.
48.
50.
TX1330 M4