Bosch GEX Professional 125 AVE Original Instructions Manual page 15
Hide thumbs
Also See for GEX Professional 125 AVE:
- Original instructions manual (11 pages) ,
- Original instructions manual (294 pages) ,
- Original instructions manual (33 pages)
Table of Contents
Available languages
Available languages
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Selecting the Sanding Sheet
Different sanding sheets are available, depending on the material you are working with and the required surface removal rate:
Material
– Paint
– Varnish
– Filler
– Bodyfiller
Expert for Wood
– All wood and wood-based ma-
terials (e.g. hardwood, soft-
wood, chipboard, construction
boards)
Best for Wood
– Hardwood
– Chipboard
– Construction boards
– Metal materials
– Car paint
– Stone
– Marble
– Granite
– Ceramic
– Glass
– Perspex
– Fibreglass reinforced plastics
Changing the sanding sheet (see figure A)
To remove the sanding sheet (10), lift it from the side and
pull it from the sanding pad (8).
Remove dirt and dust from the sanding pad (8), e.g. with a
paintbrush, before attaching a new sanding sheet.
The surface of the sanding pad (8) is fitted with a hook-and-
loop fastening, allowing sanding sheets with a similar back-
ing to be secured quickly and easily.
Press the sanding sheet (10) firmly onto the underside of
the sanding pad (8).
Bosch Power Tools
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping the hands warm,
and organising workflows correctly.
Assembly
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Application
For sanding down paint
For sanding undercoats (e.g. removing brush-
strokes, paint drips and paint runs)
For final sanding of primers prior to painting
For pre-sanding, e.g. of rough and uneven
beams and boards
For surface sanding and levelling of slight irreg-
ularities
For finish-sanding and fine sanding of wood
For pre-sanding
For shaping and edge chamfering
For fine sanding during shaping
Buffing and edge rounding
To ensure optimum dust extraction, make sure that the
punched holes in the sanding sheet are aligned with the
drilled holes in the sanding pad.
Selection of the Sanding Plate
The power tool can be fitted with sanding pads of various
hardnesses, depending on the application:
– Extra soft sanding pad: Suitable for polishing and sensit-
ive sanding even on curved surfaces.
– Soft sanding pad: Suitable for all sanding work, universal
application.
English | 15
Grit
Coarse
40
60
Medium
80
100
120
Fine
180
240
320
400
Coarse
40
60
Medium
80
100
120
Fine
180
240
320
400
Coarse
80
Medium
100
120
Fine
180
240
320
400
Very fine
600
1200
1 609 92A 7T5 | (21.06.2022)
Table of Contents
