Table of Contents
DOK-MOTOR*-MSK********-PR12-EN-P
Synchronous Servomotors MSK
8.6
Terminal box RLK1300
Pos
Components within terminal box
(3)
Terminal block U-V-W
(6)
Terminal strip (brake, temperature sensor)
(4)
Protective conductor terminal
Adapter plate (metric thread)
(5)
M25 × 1.5 / M32 × 1.5 / M40 × 1.5
8.7
Connection cables
The picture shows a terminal box, fully equipped, for double cabling.
Connection components RKL1300 / RLK1301
Tab. 8-11:
RLK1300/RLK1301, electrical connection components
Terminal box with metric thread. When ready-made, EMC screw
connection required.
Rexroth supplies ready-made power and encoder cables. The documentation
"Selecting the IndraDrive connection cable"; DOK-CONNEC-CABLE*INDRV-
CAxx-EN-P is available for selecting the cables.
The achievable service life of the cables depends on the type of installation
and environmental influences at the place of use. Observe the following rec‐
ommendations for handling the cables to ensure long and trouble-free opera‐
tion of the cables.
●
Do not load the cables with tension or torsion
Fasten the cable ends after approx. 30 cm (e.g. cable clamp, shield con‐
nection of the controllers).
●
Always pull the plug when disconnecting plug connections. Do not pull
the cable.
●
Do not bend the cable.
Bosch Rexroth AG
Connection components for cables
Wire end ferrules
Wire end ferrules
Ring terminal end M8
EMC screw connection
199/279
Connection technique
- Quick Links:
- Table of Contents
- Technical Data
Hide quick links:
Table of Contents
