Table of Contents
Outboard Rigging Guide - 2001
4.
Install:
• Fitting plate 1
• Bolts 2
Bolt:
10 Nm (1.0 m•kg, 7.2 ft•lb)
5.
Adjust:
• Shift cable joint position
Adjustment steps:
Turn the shift handle 1 in neutral posi-
•
tion.
Align the set pin 2 as shown.
•
Adjust the position of the cable joint 3
•
until its hole aligns with the set pin.
Install the clip 4 and tighten the lock
•
nut 5.
WARNING
The cable joint should be screwed in
more than 8.0mm (0.31 in).
6.
Check:
• Shift operation
Unsmooth operation → Repair.
7.
Adjust:
• Throttle cable joint position
Adjustment steps:
•
Turn the throttle grip fully close.
Align the throttle lever 1 as shown.
•
Adjust the position of the cable joint 2
•
until its hole aligns with the set pin.
Install the clip 3 and tighten the lock
•
nut 4.
WARNING
The cable joint should be screwed in
more than 8.0mm (0.31 in).
6A-9
- Quick Links:
- Table of Contents
- Wire Harnesses
Hide quick links:
Chapters
Table of Contents
