Table of Contents
Outboard Rigging Guide - 2001
5HP LIGHTING COIL
The lighting coil will allow the motor to produce
additional electrical current. With a voltage regu-
lator, the lighting coil can be used to directly
power lights or other accessories on a boat.
Maximum output of the lighting coil is 60 watts.
The lighting coil can also be used to charge the
battery when a rectifier is added.
Part Number
6E0-81303-80-00
NOTE: All other motors come with a lighting
coil as standard equipment.
Installation
1. Remove the recoil starter mounting bolts, and
remove the starter assembly.
2. Loosen the flywheel nut using the flywheel
holder and a socket wrench.
CAUTION:
The main thrust must be made in the direction
of the arrow. If not, the flywheel holder can slip
off.
Applicable Models
5 HP
3. Using the flywheel puller, remove the fly-
wheel. The flywheel puller bolts should be
inserted into the hole marked "P."
CAUTION:
Loosen the flywheel nut out only to the end of
the crankshaft until the flywheel has broken
loose. This will prevent the flywheel from com-
pletely popping off. Once the flywheel is loose,
the nut can be removed.
4. Remove the woodruff key from the crank-
shaft keyway.
5. Install the lighting coil onto the magneto base
with the two screws.
3-37
CLOCKWISE
- Quick Links:
- Table of Contents
- Wire Harnesses
Hide quick links:
Chapters
Table of Contents
