Air Purge Function On The Brine Circuit - Daikin Altherma 3 GEO Series Installer's Reference Manual
Hide thumbs
Also See for Altherma 3 GEO Series:
- Installer's reference manual (116 pages) ,
- Installation manual (40 pages) ,
- User reference manual (36 pages)
Table of Contents
11
|
Commissioning
To perform a manual air purge
To perform an automatic air purge
11.4.2 Air purge function on the brine circuit
Installer reference guide
202
The air purge function stops automatically after 30 minutes.
Conditions: Make sure all operation is disabled. Go to [C]: Operation and turn off
Room, Space heating/cooling and Tank operation.
1 Set the user permission level to Installer. See
the user permission
2 Go to [A.3]: Commissioning > Air purge.
3 In the menu, set Type = Manual.
4 Select Start air purge.
5 Select OK to confirm.
Result: The air purge starts. It stops automatically when ready.
6 During manual operation:
▪
You can change the pump speed.
▪
You must change the circuit.
To change these settings during the air purge, open the menu
and go to [A.3.1.5]: Settings.
▪
Scroll to Circuit and set it to Space/Tank.
▪
Scroll to Pump speed and set it to Low/High.
7 To stop the air purge manually:
1 Open the menu and go to Stop air purge.
2 Select OK to confirm.
Conditions: Make sure all operation is disabled. Go to [C]: Operation and turn off
Room, Space heating/cooling and Tank operation.
1 Set the user permission level to Installer. See
the user permission
2 Go to [A.3]: Commissioning > Air purge.
3 In the menu, set Type = Automatic.
4 Select Start air purge.
5 Select OK to confirm.
Result: The air purge starts. It stops automatically when done.
6 To stop the air purge manually:
1 In the menu, go to Stop air purge.
2 Select OK to confirm.
When installing and commissioning the unit, it is very important to remove all air
from the brine circuit.
4
level" [
128].
4
level" [
128].
"To change
—
—
"To change
—
—
EGSAH/X06+10UDA9W
Daikin Altherma 3 GEO
4P598592-1A – 2019.12
Table of Contents
Troubleshooting
