Suzuki Grand Vitara Service Manual page 302
Hide thumbs
Also See for Grand Vitara:
- Owner's manual (1736 pages) ,
- Service manual (836 pages) ,
- Supplementary service manual (481 pages)
Table of Contents
1D-16 Engine Mechanical: For M16A Engine with VVT
17) With hose connected, detach A/C compressor from
its bracket (if equipped) referring to "Compressor
Assembly Removal and Installation for M16 Engine
Model: in Section 7B".
CAUTION
!
Suspend removed A/C compressor at a place
where no damage will be caused during
removal and installation of engine assembly.
18) Support front suspension frame and engine rear
mounting member using jack (2).
19) Carry out Step 1) to 12) of "Removal" under "Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B" in order to
lower engine with front suspension frame.
20) Remove front suspension frame mounting bolt (1).
1
21) Remove engine rear mounting member bolt (1).
22) Before lowering engine with transmission and front
suspension frame from engine compartment,
recheck to make sure all hoses, electric wires and
cables are disconnected from engine.
23) Lower engine with transmission and front
suspension frame from engine compartment.
CAUTION
!
Before lowering engine, in order to avoid
damage to A/C compressor and P/S pump,
make clearance by rising them.
www.CarGarage.ir
24) Disconnect transmission from engine referring to
25) Remove engine with engine front mounting bracket
26) Remove clutch cover and clutch disc referring to
Installation
1) Install clutch cover and clutch disc referring to
2
I5JB0A141017-02
2) Install engine with engine front mounting bracket to
3) Connect transmission to engine referring to "Manual
4) Lift engine with transmission and front suspension
I5JB0A141018-02
5) Tighten engine rear mounting member bolt referring
6) Carry out Step 5) to 19) of "Installation" under "Front
www.CarGarage.ir
"Manual Transmission Assembly Dismounting and
Remounting: in Section 5B", if necessary.
(1) from engine front mounting (2), if necessary.
"Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C", if necessary.
"Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C", if necessary.
engine front mounting.
For tightening torque, refer to "Engine Mountings
Components: For M16A Engine with VVT", if
necessary.
Transmission Assembly Dismounting and
Remounting: in Section 5B", if necessary.
frame into engine compartment with jack.
CAUTION
!
Before lifting engine, in order to avoid
damage to A/C compressor and P/S pump,
make clearance by rising them.
to "Engine Mountings Components: For M16A
Engine with VVT".
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B" in order to
lift engine with front suspension frame.
I5JB0A141019-01
Table of Contents
