Table of Contents
2 | FHP560 Controller
Contents
Data subject to change
2
2
3
3
Fig. 6 ZS Sensors
4
4
5
6
7
9
10
11
11
12
12
13
14
15
16
17
18
19
20
21
22
23
24
25
1 Explanation Of Symbols
1.1 Key To Symbols
26
Warnings
28
Warnings in this document are identifi ed by a
warning triangle printed against a grey background.
36
Keywords at the start of a warning indicate the type
36
and seriousness of the ensuing risk if measures to
36
prevent the risk are not taken.
36
37
37
The following keywords are defi ned and can be used in this document:
38
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
38
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
38
CAUTION indicates a hazardous situation which, if not avoided, could result in minor to moderate injury.
38
NOTICE is used to address practices not related to personal injury.
39
40
Important information
41
43
This symbol indicates important information where
there is no risk to people or property.
44
44
44
45
CAUTION: DISCLAIMER
45
1 - Programming the Master BAS Building Controller is NOT provided by Bosch.
46
2 - The included sequence of operation and points list should be verifi ed to ensure
46
compliance with all required specifi cation. If not meeting specifi cation, additional
custom programming costs will be incurred.
3 - When making selections in BST to place an order, be sure to select the necessary
Bosch sensors under accessories (eg. wall sensors, duct sensors, outdoor air
47
sensors, etc) and any additional options or accessories that may be required.
47
4 - Extra DDC customization to interface with non Bosch sensors will incur additional
47
special pricing.
5 - DDC controls by others will receive unit status alarm (error / no error) but won't
be able to interpret the fault code - must use Bosch DDC to get cause of error
fault codes to BAS.
6 - On series evap, DDC (or controls by others) is required for heating and cooling
control. The controller is confi gured to prevent stage 2 compressor from running
when in heating mode. Without controls, this feature won't work properly in
heating mode as 2nd stage compressor (piped for straight cool) will cool while 1st
stage is trying to heat. Circuit 1 will have HGRH & HGBP, circuit 2 will be straight
cool.
7 - DDC controls need to be fi eld confi gured per job site requirements.
8 - When specifying controls by others to be factory mounted all request should
be submitted in writing and signed off on by both parties. Bosch will assume
no responsibility for any oversights, unspoken intents, or assumptions in factory
mounting any third-party controllers.
9 - For orders requiring special software programming a requirements specifi cation
document must be generated to notify the approving party of Bosch's
comprehension of the desired sequence. It is the responsibility of the approving
agency/individual to carefully review the requirements and ensure that all intended
actions have been clearly stated and correctly interpreted.
Page____ of ____
Applications Manual
Bosch Thermotechnology Corp.
Hide quick links:
Table of Contents
