Table of Contents
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
9-4
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Error: Could not load loader image from Management
Module, error code:[0xXXXX].
Please check network connection with management
module and network
XXXX:EFI Status Code
Reading the LPAR manager loader failed.
Check there are not any problems in a setup of a network, a LAN
switch and a connection.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Error: Could not set VLAN ID[0xXXXX],Port[0xYY],error
ZZZZ:EFI Status Code
Assignment of Tag of VLAN ID failed.
Check VLAN ID is set as a value 0 to 4094.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Error: Could not start loader.(XXXX)[0xYYYY]
LoadImage Error (The error of the program image deployed
Handle protocol Error (EFI inside error)
Start Image Error (LP-Loader Executing Error)
YYYY:EFI Status Code
Booting the LPAR manager loader failed.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Ipmi driver initialization failed, error code:[0xXXXX].
XXXX:EFI Status Code
An error was detected before IPMI command issue.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Network error occurred,retry after a few seconds.
(PortX,Cmd:[0xXXXX],detected code[0xXXXX],error
Because a network error occurred, communication with the
management path will be retried at communication port PortX
(MgmtX).
Messages
code:[0xZZZZ].
XXXX:VLAN ID
YY:Port NO.
XXXX:cause
on the memory)
code[0xXXXX])
- Quick Links:
- Configuration of Memory
Hide quick links:
Table of Contents
