Home Auto Manual large NEWEST
Step by step operating instructions for the LAMP RECEIVERS
A Quick Note before You Set Up the LAMP RECEIVERs:
WARNING: For indoor use only.
Use incandescent bulbs up to 300 watts only.
Step 1:
Set the HOUSE CODE to the same letter that you selected on the MESSENGER HUB, then plug the LAMP RECEIVER into the AC outlet
currently being used by the lamp you wish to control.
Step 2:
Select a UNIT CODE color to match the room color that you laid out on the back of the INDOOR REMOTE. Now
you will need to assign a specific UNIT CODE for the LAMP RECEIVER. Within the color that you have picked you
have 3 number choices. In the example in Figure 8 the LAMP RECEIVER is set to Yellow 8.
Step 3:
Turn lamp on first, then plug into the receptacle on the underside of the MESSENGER HUB.
Step 4:
Turn color dial on INDOOR REMOTE so that it matches the color setting on the LAMP RECEIVER. To
turn the lamp on and off, press the switch which corresponds with the number selected on the LAMP
RECEIVER. Figure 9 depicts activating LAMP RECEIVER set to Yellow 8.
NOTE: Lamps connected to LAMP RECEIVERS can still be controlled by the lamps switch. Remember
that lamp switch must be turned on in order for the lamp to be controlled by the Freewire system.
4/24/03
3:40 PM
Page 6
6
8
1
9
ON
OFF
ON
ON
ON
OFF
OFF
OFF
ON
ON
ON
MOOD 1
MOOD 2
HOUSE
OFF
OFF
OFF
