Home Auto Manual large NEWEST
PLEASE FOLLOW THE SEQUENCE LAID OUT IN THIS MANUAL TO AVOID CONFUSION
Step by step instructions to set up the MESSENGER HUB:
A Quick Note Before You Set Up MESSENGER HUB:
WARNING: For indoor use only.
Each receiver has a specific address made up of a HOUSE CODE (bottom dial) and a Unit Code (upper dial) which is used to communicate with
the MESSENGER HUB.
The function of the HOUSE CODE is to prevent interference from another FREEWIRE system. If at any time, you experience interference with
another system please choose another setting for your HOUSE CODE A - P. The letter selected must be the same on all RECEIVERS and the
MESSENGER HUB.
Step 1:
Plug MESSENGER HUB into any operational AC outlet within your home. Rotate
antenna to the upright position. Open the front door to expose control panel as
shown in Figure 1. NOTE: Placing the MESSENGER HUB on the inside wall
closest to driveway or entry way, will often maximize range of the KEY CHAIN
REMOTE.
Step 2:
Select a HOUSE CODE on the MESSENGER HUB, any letter A - P. (Note: The
house code you select for the MESSENGER HUB will dictate what letter you will
select for all of the RECEIVERS you plan to control with this MESSENGER HUB.)
Step 3:
Select a UNIT CODE on the MESSENGER HUB, any number 1 - 16. The number
and corresponding color you pick will control the lamp outlet located on the
underside of this MESSENGER HUB. (If you select the same number and same house code for any additional
receivers on this system they will operate in conjunction with this hub.)
Step 4:
Synchronize your INDOOR REMOTE with your MESSENGER HUB so they understand how to communicate with each other. (Note: Any
additional remote that is introduced to the system must also be synchronized.)
To synchronize, move the MESSENGER HUB slide switch to LEARN.
While facing the MESSENGER HUB, press and hold any "ON" button of the INDOOR REMOTE for 5
seconds - Figure 2. Be sure to see the green light flash on the MESSENGER HUB. The flash will indicate
that the MESSENGER HUB is now synchronized with the INDOOR REMOTE.
Now, move the slide switch on the MESSENGER HUB to RUN.
(Note: Door cannot be closed while MESSENGER HUB is in the LEARN mode.)
Step 5:
Turn lamp on first, then plug into the receptacle on the underside of the MESSENGER HUB. Use only
incandescent bulbs up to 500W. Be sure the Lamp has been turned on prior to plugging into MESSENGER
HUB.
Press the Local Lamp "ON/OFF" button on the MESSENGER HUB to check that the MESSENGER HUB is
operating correctly. You will hear a "click" when the MESSENGER HUB turns this lamp on and off.
You are now ready to operate the lamp connected to this MESSENGER HUB with the INDOOR REMOTE.
4/24/03
3:40 PM
Page 4
4
1
Run / Learn Slide Switch
Plug Receptacle
2
Press any
"ON" button
for 5 seconds
On/Off Button
Unit Code Dial
House Code Dial
ON
OFF
ROOM COLOR
ON
ON
ON
OFF
OFF
OFF
ON
ON
ON
MOOD 1
MOOD 2
HOUSE
OFF
OFF
OFF
