Home Auto Manual large NEWEST
Getting familiar with your
The MESSENGER HUB is the brain of the Freewire
outlet it has the ability to receive Radio Frequency (RF) signals from the remotes and the
ability to send messages through existing house wiring to all receivers that are dialed to the
same house code.
It is also used to control *incandescent lamps only, rated up to 500 watts, connected to the
plug receptacle at the bottom of the MESSENGER HUB. Note: For restrictions and
instructions see MESSENGER HUB section.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The INDOOR REMOTE sends Radio Frequency (RF) signals to the MESSENGER HUB.
These signals can go through walls, so you can use this remote to control lights (or
appliances with approved appliance receiver only) from anywhere in or around your home.
NOTE: Walls and other obstructions may reduce the effective range of the RF signal.
A LAMP RECEIVER must be used in conjunction with at least one active MESSENGER
HUB. It is used to control *incandescent lamps only rated up to 300 watts. Note: For
restrictions and instructions see LAMP RECEIVER section.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The BULB RECEIVER must be used in conjunction with at least one MESSENGER HUB. It
is used to control an indoor or outdoor incandescent light (up to 150 watts) that is normally
controlled by a wall switch.
*Do not use fluorescent, low wattage, energy saving and halogen bulbs.
The KEY CHAIN REMOTE can conveniently turn on and off a limited number of lights which
you select from the MESSENGER HUB. NOTE: For restrictions and instructions see KEY
CHAIN REMOTE section
4/24/03
3:40 PM
Page 3
tm
system. When it is plugged into an AC
3
home automation kit.
MESSENGER HUB
ON
ON
INDOOR REMOTE
OFF
MOOD 1
OFF
LAMP RECEIVER
BULB RECEIVER
KEY CHAIN REMOTE
OFF
ROOM COLOR
ON
ON
OFF
OFF
ON
ON
ON
MOOD 2
HOUSE
OFF
OFF
