Connection Of Development Pc And Controller With Ethernet - Epson RC90 User Manual
Robot controller.
epson rc+ 7.0
Hide thumbs
Also See for RC90:
- Manual (340 pages) ,
- Safety and installation (124 pages) ,
- Maintenance manual (70 pages)
Table of Contents
Setup & Operation 7. LAN (Ethernet Communication) Port
7.4
Connection of Development PC and Controller with Ethernet
Connection between the development PC and the Controller is shown below.
(1) Connect the development PC and the Controller using the Ethernet cable.
(2) Turn on the Controller.
(3) Start EPSON RC+ 7.0.
(4) Display the [PC to Controller Communication] dialog from [Setup] in EPSON RC+
(5) Click the button.
(6) Connection "No.2" is added. Set the following and click the button.
(7) [Name] and [IP Address] specified in procedure (6) is displayed.
40
7.0 menu.
Name : Valid value to identify the controller to connect
IP Address : IP address for Controller to connect
RC90 (EPSON RC+ 7.0) Rev.4
- Quick Links:
- Battery
Hide quick links:
Table of Contents
