Sample Vrf Configuration - Dell S4048–ON Configuration Manual
S-series 10gbe switches
Hide thumbs
Also See for S4048–ON:
- Configuration manual (1146 pages) ,
- Deployment manual (78 pages) ,
- Troubleshooting manual (29 pages)
Table of Contents
Table 106. Configuring a Static Route
Task
Configure a static route that points to a
management interface.
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
Table 107. Configuring a Static Entry in the IPv6 Neighbor Discovery
Task
Configure a static neighbor.
Sample VRF Configuration
The following configuration illustrates a typical VRF set-up.
Figure 156. Setup OSPF and Static Routes
966
Virtual Routing and Forwarding (VRF)
Command Syntax
management route ip-address
mask managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
Command Syntax
ipv6 neighbor vrf management
1::1 tengigabitethernet 1/1
xx:xx:xx:xx:xx:xx
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Table of Contents
Troubleshooting
