Toshiba e-STUDIO 2555C Service Manual page 717
Multifunctional digital color systems
Hide thumbs
Also See for e-STUDIO 2555C:
- Troubleshooting manual (136 pages) ,
- Copying manual (228 pages) ,
- Safety information manual (32 pages)
[CB31] Movable tray paper-full detection error
Classification
Finisher related service call
MJ-1107
Check Item
Movable tray paper-full detection
sensor (S16)
Replacement part
Movable tray paper-full detection
sensor (S16)
Finisher controller PC board
MJ-1108
Check item
Movable tray paper-full sensor
Parts to be replaced
Movable tray paper-full sensor
Finisher control PC board
[CB40] Front alignment motor abnormality
* You receive a [CB40] error when the [ED13] error occurs three times in succession.
MJ-1036
Classification
Finisher related service call
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Movable tray paper-full detection error: The actuator of the
movable tray paper-full detection sensor does not move
smoothly.
•
If there is mechanical problem when the actuator is moved,
fix the mechanism.
•
Sensor check
•
Check the connectors and harnesses between the movable
tray paper-full detection sensor (S16) and the finisher
control PC board (CN13).
Measures
Fix any mechanical problem occurring when the actuator is moved.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the movable tray paper-full sensor (S16).
If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN12) on the finisher controller PC board is
disconnected from the movable tray paper-full sensor (S16) and the
harnesses are open circuited. Correct if so.
Remark
Front alignment motor abnormality: The front alignment motor is
not rotating or the front alignment plate is not moving normally.
8 - 161
Contents
Measure
Measure
Contents
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8
- Quick Links:
- Service Manual
- Table of Contents
Hide quick links:
Troubleshooting
