Table of Contents
Safety
Installation and operation
V
CAUTION!
The server automatically sets itself to a voltage in the range of
100 V to 240 V. Make sure that your local voltage is within this range.
This device has a specially approved power cable and must only be
connected to a grounded insulated socket.
Ensure that the power socket on the device or the grounded wall
outlet is freely accessible.
The power switch or the main power switch does not disconnect the
device from the mains voltage. To disconnect the line voltage
completely, remove the power plug from the grounded insulated
socket.
V
CAUTION!
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. storage subsystem) has failed during a power outage.
Data cables must be adequately shielded.
To the LAN wiring the requirements apply in accordance with the
standards EN 50173 and EN 50174-1/2.
As minimum requirement the use of a protected LAN line of
category 5 for 10/100 MBps Ethernet, and/or of category 5e for
Gigabit Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
Route the cables in such a way that they do not form a potential
hazard (make sure no-one can trip over them) and that they cannot
be damaged. When connecting up a device, refer to the relevant
notes in this manual.
Never connect or disconnect data transmission lines during a storm
(lightning hazard).
Otherwise you run the risk of losing data if, for example, the central
processing unit is still running but the peripheral device (e.g. storage
subsystem) has failed during a power outage.
8
Options Guide
U41599-J-Z156-1-76
Chapters
Table of Contents
