Bosch Nexxt 500 Plus Series Operating, Care And Installation Instructions Manual page 23

Fault

Water cannot be seen in

drum.

Indicator light rinse" is lit

and display is flashing

E:13" with no water re

maining in tub.

Water is flowing out from

underneath the machine.

underneath the machine.

Indicator light wash" is lit

and display is flashing

E:17".

Suds coming out of the

detergent dispenser.

detergent dispenser.

Repeated spinning.

The laundry was not

spun.

Program duration ex

tended.

Unsatisfactory washing

result.

Detergent residue on the

laundry.

Gray residue on the laun

dry.

System shakes or

shudders when passing

from lower to higher

speed spinning.

If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on

again, select and start the program.

If the fault continues, call customer service; see Page 24.

Possible cause

This is not a fault.

The water level is below the visible part of the drum.

Suds or pump is blocked.

he thread of the supply hose is not tight.

T

Leak in the drain hose.

AQUASTOP 

is triggered.

Too much soap or non-HE soap used, pump could

not remove suds.

not remove suds.

This is not a fault.

The imbalance compensation system is attempting to

balance the load through repeated spins.

Large items of clothing have become entangled and

could not be distributed evenly in the drum. For safe

ty reasons the high speed spin cycle was automati

cally suppressed.

This is not a fault.

The suds detection feature has activated an addi

tional rinsing cycle to reduce the amount of suds.

This is not a fault.

The imbalance compensation system is attempting to

balance the load through repeated spins.

The degree of soiling was higher than estimated.

Not enough detergent.

Some phosphate free detergents contain water insol

uble residues that may appear as light spots on the

laundry.

Dirt accumulation from ointments, fats or oils.

Drum system suspension can shift during speed up,

this is not a failure.

Action

Use less detergent for future wash loads. Detergents

specifically designed for your High Efficiency washer

produce fewer suds and will include the letters HE"

on the packaging. Clean the water drainage pipe

and/or drain hose. Run any program to remove the

excess suds.

Tighten the thread.

Replace the drain hose.

Close water tap and investigate leak.

Mix 1 tablespoon of fabric softener with 1 pt (½ litre)

of water and pour into detergent dispenser III.

Use less detergent for future wash loads. Detergents

specifically designed for you High Efficiency washer

produce fewer suds and will include the letters HE"

on the packaging.

Always load the drum with large and small items

together.

Always load the drum with large and small items

together.

Add a more appropriate amount of detergent.

Always load the drum with large and small items

together.

Select suitable program

or

Stain removal as an additional option.

Add detergent according to the manufacturer's

specifications.

Brush off spots when laundry is dry.

Add the maximum amount of detergent and select

the highest permissible temperature.

Mix small and large laundry pieces in load to

minimize this effect.

23