During Washing; Changing A Program; Add A Garment / Interrupting The Program; Canceling Active Program - Bosch Nexxt 500 Plus Series Operating, Care And Installation Instructions Manual
Hide thumbs
Also See for Nexxt 500 Plus Series:
- Operating & installation instructions manual (264 pages) ,
- Operation & care instructions manual (88 pages) ,
- Operating, care and installation instructions manual (68 pages)
Table of Contents
Press the Start/Pause button.
q
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
i
Each program step is indicated by
the indicator lights under the
display.
During Washing
i
Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
Turn the program selector to Off.
q
Turn the program selector to a
q
newly selected program.
The Start/Pause indicator light
flashes.
If required, change the settings;
q
see from Page 17.
Press the Start/Pause button.
q
The program starts.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i
It is not recommended to add
laundry after the washing phase is
complete.
i
You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
Press the Start/Pause button.
q
The Start/Pause indicator light
flashes.
Open the door.
q
Place/remove the laundry.
q
Close the door.
q
Press the Start/Pause button.
q
The program continues.
The indicator light is lit (red).
i
When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
i
If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i
If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
Turn the program selector to Off.
q
Turn the program selector to
q
Refresh.
i
Select the desired spin speed (but
not no final spin).
Press the Start/Pause button.
q
Wait until this program ends.
q
Open the door.
q
Unload the laundry.
q
i
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i
If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
0:00 appears in the display.
Open the door.
q
Turn the program selector to Off.
q
Close the taps.
q
NOTICE
Occasionally check for any foreign
objects (e. g. coins, paper clips)
between the drum and rubber seal
-To avoid risk of rust!
Remove the laundry.
q
i
After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
19
Hide quick links:
Chapters
Table of Contents
