Table of Contents
DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config lldp ports
Parameters
the list will be advertised in the LLDP from the specified interface, associated with
each management address. The interface for that management address will be also
advertised in the if-index form.
An active LLDP port on the switch always includes the mandatory data in its
outbound advertisements. And there are four optional data that can be configured
for an individual port or group of ports to include one or more of these data types
from outbound LLDP advertisements. The mandatory data type include four basic
types of information (end of LLDPDU TLV, chassis ID TLV, port ID TLV, and
Time to Live TLV). The mandatory type cannot be disabled. There are also four
data types which can be optionally selected. They are port_description,
system_name, system_description, and system_capability.
Configure an individual port or group of ports to include one or more of IEEE 802.1
Organizationally port vlan ID TLV data types from outbound LLDP
advertisements.
Configure an individual port or group of ports to include one or more of IEEE 802.1
Organizationally port and protocol VLAN ID TLV data types from outbound LLDP
advertisements.
Configure an individual port or group of ports to include one or more of IEEE 802.1
Organizationally VLAN name TLV data types from outbound LLDP
advertisements.
Configure an individual port or group of ports to include one or more of IEEE 802.1
Organizationally protocol identity TLV data types from outbound LLDP
advertisements. This TLV optional data type indicates whether the corresponding
Local System's Protocol Identity instance will be transmitted on the port. The
Protocol Identity TLV provides a way for stations to advertise protocols that are
important to the operation of the network. Spanning Tree Protocol, the Link
Aggregation Control Protocol, and numerous vendor proprietary variations are
responsible for maintaining the topology and connectivity of the network. If
EAPOL, GVRP, STP (including MSTP), and LACP protocol identity are enabled
on this port and it is enabled to be advertised, then this protocol identity will be
advertised.
all - Specify to set all the ports on the system.
notification - Enables or disables the SNMP trap notification of LLDP data changes
detected on advertisements received from neighbor devices. The default
notification state is disabled.
enable - Enable the SNMP trap notification of LLDP data changes detected on
advertisements received from neighbor devices.
disable - Disable the SNMP trap notification of LLDP data changes detected on
advertisements received from neighbor devices.
admin_status - Select the desired administrative per port state. The default per port
state is tx_and_rx.
tx_only - Configure the specified port(s) to transmit LLDP packets, but block
inbound LLDP packets from neighbor devices.
rx_only - Configure the specified port(s) to receive LLDP packets from neighbors,
but block outbound packets to neighbors.
tx_and_rx - Configure the specified port(s) to both transmit and receive LLDP
packets.
disable - Disable LLDP packet transmit and receive on the specified port(s).
mgt_addr - The port types specified for advertising indicated management address
instance.
Page | 96
Chapters
Table of Contents
