Table of Contents
DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
D
C
EBUG
OMMANDS
Back to Section Header
The Switch Debug commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
debug address_binding
no debug address_binding
debug buffer
debug config state
debug error_log
debug output
debug show status
debug stp clear counter
debug stp config ports
debug stp show counter
debug stp show flag
debug stp show information
debug stp state
debug dhcpv6_relay state
debug dhcpv6_relay output
debug dhcpv6_relay packet
debug dhcpv6_relay
hop_count state
debug dhcpv6_client
debug show error_reboot
state
Each command is listed, in detail, in the following sections.
debug address_binding
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To open IP-MAC binding debug for event and DHCP:
P
ARAMETERS
[event | dhcp | all]
[utilization | dump | clear | upload_toTFTP ]
[enable | disable]
[dump | clear | upload_toTFTP ]
[[module ] [buffer | console] | all [buffer | console]]
{module }
{ports [ | all]}
[ | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]}
{ports [ | all]}
{ports }
[disable | enable]
[enable | disable]
[buffer | console]
{all | receiving | sending} state [enable | disable]
[enable|disable]
[[output{buffer|console}]|[packet{all state [enable | disable]|receiving state
[enable | disable]|sendingstate [enable|disable]}state [enable|disable ]
To open IP-MAC binding debug events or DHCP.
debug address_binding [event | dhcp | all]
This command is used to open IP-MAC binding debug events or DHCP.
event - Displays the debug messages when an IMPB module receives ARP/IP packets.
dhcp - Displays the debug messages when an IMPB module receives the DHCP
packets.
all - Displays all debug messages.
Only Administrator-level users can issue this command.
Page | 37
Chapters
Table of Contents
