Setting Up Bluetooth Using A 3Com Usb Adapter - Toshiba GL-1010 Administrator's Manual

Toshiba gl-1010 office mfp
Hide thumbs Also See for GL-1010:
Table of Contents
4
In the General area, enter the controller
5
Select the
6
If required, check
WEP Key
7
Select the type of
8
Enter the
9
Select the
10 Enter the identifier of the
characters (Infrastructure network type only).
11 Enter the
12 Select the
13 Enter the number of
14 Enter the
15 Enter the
16 Enter the
17 Click
For more information on wireless NIC settings, consult the Cisco Aironet
Wireless LAN Adapters 340 and 350 Series Quick Start Guide.
Troubleshooting
Problem
Transfer rate says "No connection"
There is a connection to the access
point and the printer is not visible on
the network
There is a connection to the access
point, the authentication mode is Open
System, and the printer is not visible
on the network

Setting up Bluetooth Using a 3com USB Adapter

Install the optional Bluetooth USB Adapter by inserting the USB
connector into the USB port of the controller and rebooting the controller.
150
from the drop-down list.
Network Type
Use WEP Security
, and
Authentication
WEP Encryption
as 5 or 13 sets of hex characters.
WEP Key
Authentication
Channel Number
Transmit Power
Data Retries
Fragment Threshold
.
RTS Threshold
.
RTS Retry Limit
.
Save
Troubleshooting
and
Set WEP key
fields are enabled.
from the drop-down list box.
mode from the drop-down list box.
Default Access Point
(Ad Hoc network type only).
from the drop-down list box.
.
.
Solution
Verify the access point is working
Verify SSID matches the access point
Verify WEP against the access point
Verify that the indicated settings on the Intel
card are all disabled. If it still fails, increase
the
Transmit Power Setting
Verify that the indicated settings on the Intel
card are all disabled. If it still fails, make
sure that the WEP key of the client and AP
match.
GL-10x0
.
SSID
. The
WEP Encryption
as 6 sets of hexadecimal
.
Administrator's Guide
,
Table of Contents
loading

Table of Contents