Fujitsu Sparc Enterprise T5120 Installation Manual page 130
Hide thumbs
Also See for Sparc Enterprise T5120:
- Product notes (150 pages) ,
- Safety and compliance manual (34 pages) ,
- Overview manual (34 pages)
Table of Contents
mounting brackets, 76
installing optional components, 5
IP address, 8
L
LEDs, ports, and slots illustrated, 12
left and right sides defined, 19
levers, locking, See "slide rail assembly locks"
locating pins for mounting brackets, 76
locations of ports, slots, and LEDs (illustration), 12
locks, See "slide rail assembly locks"
logging into service processor
using network management port, 51, 55
using serial management port, 51
M
map of OpenBoot PROM devices, 60
minimum cable connections, 10
modem not for use with the SER MGT serial
management port, 36
mounting bracket
locating pins on chassis, 76
preparation for installation, 76
removing from slide rail, 76
unlocking, 76
mounting screws for rack, 23
N
netmask, 8
network management port
configuring and enabling, 49
not operational until configured, 9, 49
O
OpenBoot PROM device map, 60
optional components, installation instructions in
service manual, 5
overcurrent protection device (DC models), 87, 100
P
parity for serial terminal, no, 45
password command, 51
path names, 60
pins, mounting bracket locating, 76
ports, slots, and LEDs illustrated, 12
108
SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
power cycling the system, 63
powering on the system for the first time, 43
poweroff command, 64
poweron command, 56, 59
R
removing server from rack, 40, 84
reset
resetting the system with uadmin, 63
restricted-access location (DC models), 85
right and left sides defined, 19
right side defined, 19
RJ-45 cable, 11
S
screws for rack mounting, 23
serial terminal
settings, 45
service processor
access with network management port, 55
access with serial management port, 51
connecting to the system console, 58
network management port not operational until
configured, 9
powering on for the first time, 44
powering on the system, 56
See also ILOM
set command, 53
set command, 53
show /SP/network command, 54
show-disks command, 61
slide rail assembly locks illustrated
front slide rail locks, 20
middle section lever, 21
mounting bracket locating pin lock, 23
mounting bracket release button, 21
slide rail spacing tool, 24
slots, ports, and LEDs illustrated, 12
Solaris media kit contents, 10
spacing tool for slide rails, 24
Standby mode, 39
standby voltage causes service processor to power
on, 9
standby voltage, 3.3v, 47
stop bit, 45
Table of Contents
