Table of Contents
Related Manuals for GE ZGU36L6D
Summary of Contents for GE ZGU36L6D
-
Page 1: Gas Cooktops
® GE Monogram Installation Instructions Professional Gas Cooktops 48" Natural Gas Models ZGU48N4G ZGU48N6R ZGU48N6D 48" LP Gas Models ZGU48L4G ZGU48L6R ZGU48L6D 36" Natural Gas Models ZGU36N6 ZGU36N4R ZGU36N4D 36" LP Gas Models ZGU36L6 ZGU36L4R ZGU36L4D... -
Page 2: Table Of Contents
National Electrical Code ANSI/NFPA 70-1990. CAUTION: These cooktops are extremely heavy. Due to the weight and size of the cooktop and to reduce the risk of personal injury or damage to the product, TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION. -
Page 3: Design Information
All models require the installation of a Accessory backguard or trim. A backguard/trim should be Requirements ordered at the same time as the cooktop. Both should be on site at the time of installation. 48" backguards, order one: ZXC1B48 1/2" trim backguard (required for island installations or installations where back wall is non-combustible;... -
Page 4: Product Dimensions And Clearances
Product 47-7/8" Dimensions & Clearances 48" Wide Models 2-1/2" 36" Wide Models Design Information 26-5/8" 8-7/16" 18" Min. 7/8" 8" 26-5/8" 8-7/16" 18" Min. 1/2" 2-1/2" 8" 26-5/8" 10" 2-1/2" High 21-1/4" Shelf 12" Low Back Professional Gas Cooktops 48" Wide Hood 13"... -
Page 5: Installation Options
Options • In 24" deep cabinets, the front of the cooktop will project approximately 1-7/8" beyond the front of the countertop. • In 25" deep cabinets, the cooktop will be flush with the front of the countertop. 21-1/4" High Back... -
Page 6: Tools & Materials Required
Locate Gas Supply 2" Maximum Protrusion From Wall or on Floor 2" From Wall • Locate the electric supply within the area shown or within reach of the cooktop’s six foot power cord. • To avoid tangling cord with items stored in the cabinet, locate the receptacle on rear wall, inside the cabinet. -
Page 7: Installation
Use a hand-truck to move this cooktop. S tep Before moving the cooktop indoors: • Remove outer carton and packing. Remove • Remove the straps holding the cooktop to the skid. Packaging • Remove the grates and drawers below the knobs. -
Page 8: Step 3: Install The Cooktop
Connect the gas inlet location at the left rear corner. Cooktop • Pull the flexible metal gas line through the back or bottom of the cooktop until it meets the to Gas regular. • Connect flexible metal connector to incoming gas line pipe stub. -
Page 9: Step 6: Connect Electrical
Step Plug power cord into properly grounded receptacle. Connect Electrical • Replace the burner bowls and burner caps. • Adjustments should not be required, unless Step vibration during transit or variations in local gas supply make minor adjustments neces- sary. Assemble Burners, CAUTION: Burner adjustments must be made... -
Page 10: Adjustable Low Burner Settings
(3/32" blade width recommended.) Place the burner grates into operating position. Finalize Press corner of the grate to the cooktop. The Installation grates should be seated and should not rock. The grill and griddle are secured with screws at the front. - Page 11 Notes Professional Gas Cooktops...
- Page 12 Pub. No. 49-8812-6 Dwg. No. 164D3333P056 (N.D. 760) 4/03 10659 - Rev. 6 Note: While performing installations described in this book, safety glasses or goggles should be worn. ® For Monogram local service in your area, call 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric.