GE Monogram ZGU48N4G Installation Instructions Manual

Hide thumbs Also See for Monogram ZGU48N4G:

Quick Links

Installation
Instructions
Professional Gas Cooktops
48" Natural Gas Models
ZGU48N4G
ZGU48N6R
ZGU48N6D
48" LP Gas Models
ZGU48L4G
ZGU48L6R
ZGU48L6D
36" Natural Gas Models
ZGU36N6
ZGU36N4R
ZGU36N4D
36" LP Gas Models
ZGU36L6
ZGU36L4R
ZGU36L4D
0
Monogram.*
Table of Contents
loading

Summary of Contents for GE Monogram ZGU48N4G

  • Page 1 Installation Instructions Professional Gas Cooktops 48" Natural Gas Models ZGU48N4G ZGU48N6R ZGU48N6D 48" LP Gas Models ZGU48L4G ZGU48L6R ZGU48L6D 36" Natural Gas Models ZGU36N6 ZGU36N4R ZGU36N4D 36" LP Gas Models ZGU36L6 ZGU36L4R ZGU36L4D Monogram.*...
  • Page 2 Installation Instructions CAUTION: BEFORE YOU BEGIN THESE C00KTOPS SHOULD BE INSTALLED Read these instructions completely and IN CONJUNCTION WITH A SUITABLE carefully. OVERHEAD VENT HOOD. Due to the high heat capacity IMPORTANT- • Save these instructions for of this unit, particular attention should be paid to the local inspector's use.
  • Page 3: Table Of Contents

    ZGU36N4R- 4 gas burners and grill 48" Natural Gas Models: ZGU36N6- 6 gas burners ZGU48N4G - 4 gas burners, grill and griddle 36" Liquid Propane Gas Models: ZGU48N6R -6 gas burners and grill ZGU36L4D- 4 gas burners and griddle...
  • Page 4: Product Dimensions And Clearances

    Design Information PRODUCT DIMENSIONS AND CLEARANCES 48" Wide Models Refer Hood 36* Min to installation Combustible 18" Min instructions Material From Cooking Allow Additional Clearance Surface Below the CooktopBurner Boxfor the Regulatorand GasConnections 22-3/4"Min 36" Wide Models 8-7/16" 36" Min to Allow Additional Clearance Installation Combustible...
  • Page 5: Installation Options

    Installation Preparation INSTALLATION OPTIONS ADVANCE PLANNING These cooktops can be installed in standard 24" or Refer to "Dimensions and Clearances" for appropriate deeper 25" cabinets. placement and necessary clearances when planning the installation. • In 24" deep cabinets, the front of the cooktop will project approximately 1-7/8"...
  • Page 6: Tools And Materials Required

    Installation Preparation TOOLS REQUIRED MATERIALS REQUIRED (not supplied) • Pipe and fittings as required • Saw • Measuring tape • Manual gas line shut-offvalve • Carpenter's square • Gas pressure regulator (supplied) • Large flat-blade screwdriver • Gas-resistantpipe joint sealant •...
  • Page 7: Step 1 Remove Packaging

    Installation STEP 1 REMOVE PACKAGING Use a hand-truck to move this cooktop. • Flatten the carton and use a piece as a pad on the bottom and back of the hand-truck. Uft the cooktop onto Before moving the cooktop indoors: the hand-truck standing on its end, with the bottom of the cooktop resting against the back of the hand-truck.
  • Page 8: Step 3, Install The Cooktop

    Installation STEP 3 INSTALL COOKTOP • Lower the cooktop into the opening. Make sure the cooktop is evenly seated and supported. A side frame gasket will seal the cooktop to the countertop. • "L" brackets with screws are provided to secure the cooktop to the countertop or to adjacent cabinetry.
  • Page 9: Step 5, Connect Electrical

    Installation I STEP 5 CONNECT ELECTRICAL Plug power cord into properly grounded receptacle. STEP 6 ASSEMBLE BURNERS, CHECK IGNITION Assemble burners as shown. Check to be sure that burner heads and caps are securely seated. Pin(s) must f Burner Cap completely engage holes to ensure proper assembly.
  • Page 10: Finalize Installation

    Installation FINALIZE INSTALLATION Place the burner grates over the burners. Press corner The griddle has two leveling screws beneath the rear of the grate to the cooktop. The grates should be seated flue cover that can be used to adjust to the desired slope. and should not rock.
  • Page 11: Install The Cooktop Backsplash Accessory

    Installation INSTALL 9" or 12" HIGH BACKSPLASH Slotsfar Verticat_ Adjustment • Install and level the range or cooktop according to the Sacksection installation instructions. • Remove the backsplash packaging. Select the back, wall mount panel with mounting screw slots. 1/8'L •...
  • Page 12 NOTE: l roduct improve'men t is a continuing _ ndeavor g_'nera[ Electric. Therefore, materials, app_ arancc alld specifications are sul)iect to change without notice. Monogram Pub.No. 4£-80225-2 PartNo. 64D4290P377 GE Consumer& Indus_al 17713Rev.2 £ouita#l_, l_ g_2_3 1o-o4 J R _O04 0E Companv...

Table of Contents