GE JGS905 Installation Instructions Manual
  1. Manuals
  2. Brands
  3. GE Manuals
  4. Ranges
  5. Profile JGS905
  6. Installation instructions manual
GE JGS905 Installation Instructions Manual

GE JGS905 Installation Instructions Manual

Gas slide-in range
Hide thumbs Also See for JGS905:
Available languages

Available languages

Quick Links

See also: Owner's Manual
I Ilnstallation
I Gas Slide-In Rangel
nstructions
JGS905, JGS968, PGS968
Ir_
Questions?
Call 800.GE.CARES
(800.432.2737)
or Visit our Website
at: ge.com
In Canada,
call 1.800.361.3400
or Visit our Website
at: www.geappliances.ca
I
IN THE COMMONWEALTH
OF
MASSACHUSETTS:
• This product
must
be installed
by a
licensed
plumber
or gas fitter.
• When
using ball-type
gas shut-off
valves,
they shall be the T-handle
type.
• A flexible
gas connector,
when
used, must
not exceed 3 feet.
PARTS INCLUDED
Screws
Rear Filler
2 Screws
Anti-Tip
Bracket
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT - Save t hese
instructions
for local
inspector's
use.
• IMPORTANT - Observe all
governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with
the Consumer.
• Note to Consumer
- Keep these
instructions
for future
reference.
• Product
failure
due to improper
installation
is not covered
under
the Warranty.
-&WARNING
-
This appliance
must
be properly
grounded.
•
IMPORTANT
-
Leak testing
of the
appliance
shall
be conducted
according
to
the manufacturer's
instructions.
• Proper installation
is the responsibility
of the installer
and product
failure due to
improper
installation
is NOT covered
under
warranty.
MATERIALS
YOU MAY NEED
Joint Sealant
Pipe Fittings
Shut Off Valve
CSA-Approved
Flexible
Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum
Length (Massachusetts
Only)
TOOLS YOU WILL NEED
1/4" Nut Driver
Phillips
Head
Screwdriver
Tape Measure
Safety
Glasses
Level
Pipe Wrench
Wrench or Pliers
(for 1-7/16" Nut)
Drill
31-10665
10-07 JR
1
loading

Related Manuals for GE JGS905

Summary of Contents for GE JGS905

  • Page 1 I Ilnstallation I Gas Slide-In Rangel nstructions JGS905, JGS968, PGS968 Questions? Call 800.GE.CARES In Canada, call 1.800.361.3400 (800.432.2737) or Visit our Website or Visit our Website at: www.geappliances.ca at: ge.com IN THE COMMONWEALTH PARTS INCLUDED MASSACHUSETTS: • This product must...
  • Page 2 Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY: This range has been design certified UNDERWRITERS LABORATORIES for use in WARNING - Iftheinformation the United States and Canada. You'll find safety precautions in your Owner's Manual. this manual is not followed exactly, a fire, Read them...
  • Page 3 Installation Instructions ELECTRICAL REQUIREMENTS ANTI-TIP DEVICE This appliance must be supplied with the AWARNING - Toreduce therisk proper voltage and frequency and connected of tipping, the appliance must be secured to an individual, properly grounded branch properly installed Anti-Tip bracket packed circuit, protected...
  • Page 4 To obtain Kits: a. Visit GE Web Site (See page b. Call GE Answer Center (See page c. Contact Dealer _-I CAREFULLY, TILT RANGE TO ACCESS RANGE LEVELING LEGS...
  • Page 5 Installation Instructions REMOVE THE DOOR IF REMOVE THE DOOR NECESSARY NECESSARY (cont.) Door removal is not a requirement LIFT OFF DOOR installation of the product, but is an added Lift door up and out until the hinge arms convenience, To remove the door: clear the slots.
  • Page 6 Installation Instructions PRE-INSTALLATION CHECKLIST (CONT.) PRE-INSTALLATION CUTOUT STANDARD INSTALLATION AND REQUIRED CLEARANCES If the construction of your cabinet cannot If cabinets are placed less than 30" above provide a 1/4" flat area at the back of the range, see Alternate Construction, Step 19E,...
  • Page 7 Installation Instructions ELECTRICAL CONNECTIONS INSTALLATIONmELECTRICAL CONNECTIONS Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it is a UL listed 3-wire grounding-type...
  • Page 8 Installation Instructions GAS CONNECTIONS MAKING THE CONNECTIONS MAKING THE CONNECTIONS (cont.) Install 1/2" flare union adaptor to the 1/2" NPT elbow on pressure regulator. Connect flexible appliance connector flare union. Move range into approximate position 15" and connect flexible connector to gas Install a manual...
  • Page 9 Installation Instructions INSTALL THE RANGE INSTALL THE ANTI-TIP BRACKET INSTALL THE ANTI-TIP BRACKET (cont.) LOCATE THE BRACKET a. Decide whether the bracket will be INSTALL THE BRACKET IN WOOD installed on the right or left side of the OR CONCRETE range opening.
  • Page 10 Installation Instructions INSTALL THE RANGE (CONT.) SLIDE RANGE INTO OPENING SLIDE RANGE INTO OPENING (cont.) Position the range in front of the cabinet opening. Plug the range cord into the receptacle. Locate the cord in the back of the range Make sure that the glass which overhangs in a manner...
  • Page 11 Installation Instructions REPLACE THE OVEN DOOR REPLACE THE STORAGE DRAWER NOTE: The oven door is heavy. You may need help lifting the door high enough to slide it Place the drawer rail on the guides. into the hinge slots. Do not lift the door by Push the drawer in until it stops.
  • Page 12 Installation Instructions INSTALL THE RANGE (CONT.) CHECK FOR LEAKS COOKTOP BURNERS Turn the gas supply on and use a liquid leak ASSEMBLING THE BURNERS detector (soap solution) at all joints connections to check for leaks. Do not use an CAUTION: The electrode of t he open flame to look for leaks.
  • Page 13 Push and turn a burner valve to the LITE proper length, call GE Service. position. • The burner valve should light when is available to the burner. • Once the burner...
  • Page 14 Installation Instructions INSTALL THE RANGE (CONT.) BAKE AND BROIL BURNERS ADJUST THE AIR SHUTTER BAKE BURNER If the bake and/or broil burners have lifting "lazy" (floating) flames or you have a yellow 1. Remove the orifice fitting cover. flame, perform the following procedures: 2.
  • Page 15 Installation Instructions When the trim is set in the proper position, ALTERNATE CONSTRUCTION tighten the 2 mounting screws. The top of the PREPARATION trim should be located below the top surface of the glass to prevent pots, pans and skillets OPTIONAL MAINTOP FILLER...
  • Page 16 Installation Instructions INSTALL THE RANGE (CONT.) Please see L.P. conversion instructions r_] ALTERNATE CONSTRUCTION supplied with this range when L.P. Gas PREPARATION (cont.) is used. FOR CABINET OPENINGS NOTE: Instructions are mounted APPROXIMATELY 30-3/8" regulator bracket. If range is installed in cabinet opening approximately...
  • Page 17 Instructions Cuisiniere encastr d'installation au gaz JGS905, JGS968, PGS968 i vous avez des questions, appelez le 1.800.361.3400 ou visitez notre site Web a I'adresse www.electromenagersge.ca MATI_RIAUX DONT VOUS POUVEZ AVANT DE COMMENCER AVOIR BESOIN Lisez ces instructions completement et avec soin.
  • Page 18 Instructions d'installation CONSEILS DE SI:!:CURITI:!: IMPORTANTS VOTRE SI_CURITE_ : La conception de cette cuisiniere 6te certifiee par les UNDERWRITERS AVERTISSEMENT LABORATORIES du Canada. Vous trouverez des precautions de securite dans votre Si vous ne suivez pas exactement Manuel du proprietaire. Lisez-les avec soin.
  • Page 19 Instructions d'installation EXIGENCES ELECTRIQUES IVII CANISIVIE ANTI-BASCULANT Cet appareil menager doit 6tre livre avec le -&AVERTISSEMENT - Pour reduire bon voltage et la bonne frequence et branche le risque de basculement, vous devez fixer votre son propre circuit de derivation bien mis appareil en installant bien le support...
  • Page 20 Pour obtenir les trousses FAITES BASCULER AVEC SOIN LA CUISINII=RE POUR AVOIR a. Visitez le site Web GE (voir page 1) ACCI=S AUX PIEDS b. Appelez le centre de reponse (voir page 1) D'INCLINAISON DE LA c.
  • Page 21 Instructions d'installation ENLEVEZ LA PORTE Sl C'EST ENLEVEZ LA PORTE SI C'EST NECESSAIRE NI_CESSAIRE (suite) II n'est pas indispensable d'enlever la porte ENLEVEZ LA PORTE EN LA pour installer votre cuisiniere, mais cela SOULEVANT peut vous faciliter la t&che, Pour enlever la porte Enlevez la porte...
  • Page 22 Instructions d'installation LISTE DE VITRIFICATION AVANT L'INSTALLATION (SUITE) DECOUPE AVANT L'INSTALLATION INSTALLATION NORMALE ET DCGAGEMENT REQUIS Si la construction ou votre armoire ne peut Si les armoires sont placees a moins fournir une surface plate de 6 mm (1/4") 76,2 cm (30") au-dessus de la cuisiniere, I'arriere de I'ouverture...
  • Page 23 Instructions d'installation BRANCHEMENT I:!:LECTRIQUE INSTALLATIONm BRANCHEMENT I LECTRIQUE cause des risques de securite dans certaines conditions, nous vous recommandons fortement de ne pas utiliser de rallonge. Cependant, si vous decidez tout de m_me d'utiliser rallonge, il est absolument necessaire que cette rallonge soit une rallonge pour...
  • Page 24 Instructions d'installation BRANCHEMENT DU GAZ BRANCHEMENT BRANCHEMENT (suite) Installez I'adaptateur evase de 13 mm (1/2") au coude NPT de 13 mm (1/2") sur le r_gulateur de pression. 7,6 cm (3") ', 17,8 cm (7") Branchez le raccord flexible d'appareil manager a I'adapteur.
  • Page 25 Instructions d'installation INSTALLATION DE LA CUISINII RE INSTALLEZ LE SUPPORT INSTALLEZ LE SUPPORT ANTI-BASCULEMENT ANTI-BASCULEMENT (suite) TROUVEZ LE SUPPORT INSTALLEZ LE SUPPORT DANS DU BOIS OU DANS DU ClMENT a. Decidez si vous devez installer le support du cSte droit ou du cSte gauche I'ouverture pour...
  • Page 26 Instructions d'installation INSTALLATION DE LA CUISINII RE (SUITE) FAITES GLISSER LA CUlSINII_RE I'_ FAITES GLISSER LA CUlSINII_RE DANS L'OUVERTURE DANS L'OUVERTURE (suite) Placez la cuisiniere en face de I'ouverture Branchez le cordon de la cuisiniere dans le receptacle. Placez le cordon a I'arriere de la de I'armoire,...
  • Page 27 Instructions d'installation REMETTEZ EN PLACE LE TIROIR REMETTEZ EN PLACE LA PORTE DE LA CUISINII_RE DE RANGEMENT Placez les rails du tiroir sur les guides. NOTE : La porte de la cuisiniere est Iourde. Vous aurez peut-_tre besoin d'aide pour Poussez le tiroir a I'int6rieur...
  • Page 28 Instructions d'installation INSTALLATION DE LA CUISINII RE (SUITE) r_] BRULEURS DE LA TABLE DE VI_RIFIEZ QU'IL N'Y A PAS DE FUlTE CUISSON Allumez I'alimentation de gaz et utilisez detecteur de fuite liquide (solution savonneuse) sur tousles joints et les connexions pour ASSEMBLAGE DES BROLEURS...
  • Page 29 Instructions d'installation VI_RIFIEZ LES ALLUMEURS FLAMMES DU BRULEUR Vous devez verifier le fonctionnement Tournez chaque brQleur en position allumeurs electriques apres avoir verifie (marche). Tournez chaque bouton de brQleur soigneusement I'absence de fuite et apres avoir en position elevee. Les flammes doivent _tre branche la table de cuisson a I'alimentation...
  • Page 30 Instructions d'installation INSTALLATION DE LA CUISINII RE (SUITE) BRULEURS DE CUlSSON AJUSTEZ LE VOLET A AIR DE GRILLADE BRULEUR ARRII_RE 1. Enlevez le couvercle recouvrant I'orifice. Si les brQleurs de cuisson et/ou de grillade ont des flammes {{paresseuses>> (flottantes) 2. Utilisez un tournevis pour desserrer...
  • Page 31 Instructions d'installation Quand la garniture est posee dans la bonne PRI PARATION POUR UNE position, serrez les 2 vis de montage. Le haut AUTRE CONSTRUCTION de la garniture doit se trouver au-dessous la surface du haut du verre pour emp6cher TROUSSE DE REMPLISSAGE les casseroles,...
  • Page 32 Instructions d'installation INSTALLATION DE LA CUISINII RE (SUITE) Veuillez consulter les instructions de PRI_PARATIONS POUR UNE AUTRE conversion au gaz de petrole liquefie fournies CONSTRUCTION (suite) avec cette cuisiniere quand vous utilisez du gaz de petrole liquefi& POUR LES OUVERTURES D'ARMOIRE NOTE : Les instructions sont fixees au support...

This manual is also suitable for:

Jgs968Pgs968Jgsp48Pgs96