Hitachi WJ200 Series Instruction Manual page 387
Wj200 series single-phase input 200v class three-phase input 200v class three-phase input 400v class
Hide thumbs
Also See for WJ200 Series:
- Quick reference manual (131 pages) ,
- Instruction manual (30 pages) ,
- Installation manual (20 pages)
Table of Contents
C−6
Func.
Code
DC braking time for
A055
deceleration
DC braking / edge or level
A056
detection for [DB] input
DC braking force at start
a057
DC braking time at start
a058
Carrier frequency during DC
a059
braking
Frequency upper limit
A061
Frequency upper limit,
A261
2nd motor
Frequency lower limit
A062
Frequency lower limit,
A262
2nd motor
Jump freq. (center) 1 to 3
A063
A065
A067
Jump freq. width (hysteresis)
A064
1 to 3
A066
A068
Acceleration hold frequency
A069
"A" Function
Name
Sets
braking, range is from 0.0 to
60.0 seconds
Two options; select codes:
00...Edge detection
01...Level detection
Level of DC braking force at
start, settable from 0 to 100%
Sets
braking, range is from 0.0 to
60.0 seconds
Carrier frequency of DC
braking performance, range is
from 2.0 to 15.0kHz
Sets a limit on output
frequency less than the
maximum frequency (A004).
Range is from frequency lower
limit (A062) to maximum
frequency (A004).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output
frequency less than the
maximum frequency (A204).
Range is from frequency lower
limit (A262) to maximum
frequency (A204).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output
frequency greater than zero.
Range is start frequency (B082)
to frequency upper limit (A061)
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output
frequency greater than zero.
Range is start frequency (B082)
to frequency upper limit (A261)
0.0 setting is disabled
>0.0 setting is enabled
Up to 3 output frequencies can
be defined for the output to
jump past to avoid motor
resonances (center frequency)
Range is 0.0 to 400.0 Hz
Defines the distance from the
center frequency at which the
jump around occurs
Range is 0.0 to 10.0 Hz
Sets the frequency to hold
acceleration, range is 0.0 to
400.0Hz
Description
the
duration
for
DC
the
duration
for
DC
Run
Defaults
Mode
Lnitial data
Units
Edit
0.5
sec.
01
−
0.
%
0.0
sec.
5.0
sec.
0.00
Hz
0.00
Hz
0.00
Hz
0.00
Hz
0.0
Hz
0.0
0.0
0.5
Hz
0.5
0.5
0.00
Hz
Table of Contents
Troubleshooting
