Miscellaneous Functions - Hitachi WJ200 Series Instruction Manual
Wj200 series single-phase input 200v class three-phase input 200v class three-phase input 400v class
Hide thumbs
Also See for WJ200 Series:
- Quick reference manual (131 pages) ,
- Instruction manual (30 pages) ,
- Installation manual (20 pages)
Table of Contents
3−100
Miscellaneous Functions
The following table contains miscellaneous functions not in other function groups.
Func.
Code
Debug mode enable *
C091
Up/Down memory mode
C101
selection
Reset selection
C102
Restart mode after reset
C103
UP/DWN clear mode
C104
CAUTION: Do not change the debug mode for safety reasons. Otherwise unexpected
performances may occur.
"C" Function
Name
Displays debug parameters.
Two option codes:
00...Disable
01...Enable
(for factory use)
Controls speed setpoint for the
inverter after power cycle.
Two option codes:
00...Clear last frequency (return
to default frequency F001)
01...Keep last frequency adjusted
by UP/DWN
Determines response to Reset
input [RS].
Four option codes:
00...Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01...Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
02...Cancel trip state at input ON
transition, no effect if in Run
Mode
03...Clear the memories only
related to trip status
Determines the restart mode after
reset is given, three option codes:
00...Start with 0 Hz
01...Start with freq. matching
02...Start with active freq.
matching
Freq. set value when UDC signal
is given to the input terminal, two
option codes:
00...0 Hz
01...Original setting (in the
EEPROM memory at power
on)
Description
Defaults
Run
Mode
Lnitial data
Units
Edit
00
00
00
00
00
−
−
−
−
−
Table of Contents
Troubleshooting
