Required Preparation Before Disassembly; Orientation Definition - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

Color inkjet printer
Hide thumbs Also See for R260 - Stylus Photo Color Inkjet Printer:
Table of Contents
EPSON Stylus Photo R260/R265/R270, R360/R380/R390
Protecting the exterior parts from scratches and scuff marks
Have a commercially available 250cm-width x 100cm-length vinyl sheet to cover the
exterior parts, and secure the sheet with 60mm-length strong tape (fold one end by
5mm).
Front Cover
Fold the vinyl sheet in half, and insert the folded sheet between the Stacker Assy
and the Front Cover with the folded side facing front side of the printer. Align the
left and right edges of the sheet with the edges of the Stacker Assy and secure the
sheet with the strong tape as shown below.
Align the edges with Stacker edges
When the Front Cover is closed
Figure 4-5. Protecting the Front Cover
Panel Unit (R260/R265/R270 only)
Fold the vinyl sheet in half, and put the sheet on the Panel Unit aligning the sheet's
not-folded side with the upper edges of the buttons, and sheet's left edge with the
left edge of the Panel Unit. Then secure the sheet with the strong tape.
Align with Panel left edge and button upper edges
Figure 4-6. Protecting the Panel Unit (R260/R265/R270 only)
Disassembly/Assembly
30mm
Vinyl Sheet
folded in half
Folded side
Vinyl sheet
folded in half
30mm
Folded side
Overview

4.1.5 Required Preparation before Disassembly

Make sure to carry out the following operations before disassembling the printer.
When the Main Board needs to be replaced, make a backup copy of EEPROM
data.
Unlock the carriage lock and move the CR Unit to other than its home position.
How to Unlock the Carriage (p62)

4.1.6 Orientation Definition

Orientation descriptions used in the disassembly/reassembly procedures are as follows.
[Left side]
Figure 4-7. Orientation Definition
Revision B
[Rear side]
[Right (home) side]
[Front side]
61

Hide quick links:

Table of Contents
loading

Table of Contents